USDT 2004B Installation and User’s Guide Introduction General Information 2 Installation Collector Sensor 3
10 T roubleshooting In general, all of the settings in the menus Par and Men and the terminal should first be checked if there is a malfunction.
2Introduction Note: The information supplied in this manual is for guidance only - no part of this may be used for any agreement, whether express
3 INSTALLATION Note: This installation procedure is for guidance only, and the installer should verify its suitability. Make sure that the so
4l Collector sensor (red cable with protective terminal box): Either push into a thermowell, (sensor pocket), which is soldered or riveted directl
5 Undo the screw at the top of the housing. The control electronics are mounted on the enclosure cover. The controller enclosure can be screwed t
6 ower Connections: A small blade screwdriver may be used to fasten miniaturized terminal block screws while the corresponding wire is inserted.
7ò Push selection key once to enter the advanced (Par or *Men) mode. Once in selected mode, press one more time to select the parameter in that mo
8Par Using the navigation key ^_ allows you to select the desired parameter while you are in the program mode. Press the selection key ò once to
9 Manual Operation Mode This mode allows the user to manually turn the pump on or off. AUTO The above display indicates that the unit is w
Commentaires sur ces manuels